HyperForum — Had some issues with lvm2, a while back,

Re: Had some issues with lvm2, a while back,

2021-07-19T05:40:20Z

zapper wrote:

...
When issues like this pop up, I wish someone would post the solution to it sooner...
...

I wasn't really sure that the problem was a systemic fault or something i messed up myself (because i test a lot of stuff right now) until i saw your post.

Should have been obvious from the package update timeline, but i needet some time to figure it out.

Re: Had some issues with lvm2, a while back,

2021-07-18T21:51:22Z

the_hype wrote:

for all who had the same problem: you can fix it in the initramfs with:
vgchange -a y my-volume-group (default matrix)
exit (reboot)
and pacman -Syu (lvm2 reinstall)

When issues like this pop up, I wish someone would post the solution to it sooner...

Oh well, its over and done with I suppose. But yeah, if you see any hazards like this, please report them here.

Although I do admit I shouldve tested with qemu first. ;0

Re: Had some issues with lvm2, a while back,

2021-07-18T20:39:31Z

for all who had the same problem: you can fix it in the initramfs with:

lvm vgchange -a y my-volume-group (default matrix)

exit (reboot)

and pacman -Syu (lvm2 reinstall)

edit: lvm vgchange -a y my-volume-group (default matrix)

Had some issues with lvm2, a while back,

2021-07-18T16:38:54Z

so I kind of have to readd you throgh and rachad on tox. I didn't back up enough of my tox configs...

That being said, I went through a three day challenge lol trying to get my Hyperbola 0.4 install back to normal.

I used disk cloning though to simplify it.

The current lvm2 works fine, but still has errors when it boots.

Heh, but it least I can boot it up completely.

That being said, anytime you reinstall it now, you can see the linux image isn't complete, but it does at least boot properly.