1 Topic by bdbbott

  • bdbbott
  • Beginner
  • Offline
  • From: Mother Earth
  • Registered: 2026-02-09
  • Posts: 2

Topic: How to add a module to Hyperbola startup?

Hello. How to add a module to system startup? I need tun to start without entering "doas modprobe tun" every time. Thanks big_smile.

2 Reply by throgh

  • throgh
  • throgh
  • Package Development
  • Offline
  • From: Planet Earth
  • Registered: 2017-12-28
  • Posts: 3,086

Re: How to add a module to Hyperbola startup?

Please look next time for the correct category to place your thread into: This is a system-question. Not for the category "General".
To load modules you need first to look on your used init-system. Hyperbola GNU/Linux-libre has two of them: openrc and runit.

I assume you are using openrc (hyperrc) per default. So the file you look into is /etc/conf.d/modules.

There you can uncomment and add your preferred modules to be loaded at boot-time.

Human being in favor with clear principles and so also for freedom in soft- and hardware!

Certainly anyone who has the power to make you believe absurdities has the power to make you commit injustices: For a life of every being full with peace and kindness, including diversity and freedom. Capitalism is destroying our minds, the planet itself and the universe in the end!