Topic: Missing Programs on Install ISO
I'm attempting to install Hyperbola on my librebooted x200 (not sure if that's of any importance here). I wiped my drive clean via the dd command and I'm following the guide to setup full disk encryption alongside my install. The problem is that many of the commands in the installation guide don't seem to be present on my live iso (I made the bootable usb with dd as well if that's of any importance). I'm not the most advanced linux user but I can at least follow guides/manuals. The commands cryptsetup and cfdisk are the two missing commands holding me back at the moment, and I tried to load the "md-mod" module but checking with "lsmod | grep md-mod" found nothing, which I'm sure is why cryptsetup won't work, but I don't think md-mod holds cfdisk (could be wrong).
I've tried the "modprobe md-mod" command multiple times, and still nothing. I then tried again after replacing "md-mod" with "md_mod" and the module loaded, but cryptsetup still is unrecognized as a command.
Any help would be greatly appreciated as I'm at bit of a standstill with my installation until I can figure this out, hopefully it's not an obvious reason I'm overlooking .